Semi-Inground Pool Installation in Merritt Island, Florida

A semi-inground pool is set partway into the ground instead of sitting fully on top of it. The crew excavates the pool area, set the wall to the depth the yard and the pool model allow, backfill and support the buried side, and finish the exposed side with decking or grade work. It is the usual answer on a sloped yard, where the high side gets cut in and the low side stays above grade.

What Merritt Island yards mean for this job

Sandy fill over a high water table is the norm, which limits how deep a semi-inground install can go. Canal-front lots can be soft near the seawall, so pool placement gets set back from the bank.

Many lots are canal-front with a fence to the waterline and limited machine access down one side. Interior lots off Courtenay are flatter and easier to reach.

Where we work in Merritt Island

The crew installs throughout North Merritt Island off Courtenay Parkway, in the canal neighborhoods around Sykes Creek and Newfound Harbor, near the Merritt Square area, and in South Merritt Island toward Pineda.

What about permits?

Merritt Island is unincorporated and falls under Brevard County. Requirements depend on your address, so contact the county building department to find out what applies to your project.

What's included

• A site visit to check slope, soil, water table, and equipment access
• Layout, sod removal, and excavation of the pool area
• Setting the wall to the buried depth your pool model allows [VERIFY BURY DEPTH LIMITS FOR YOUR POOL MODEL]
• Level, compacted base pad and cove
• Backfill and support around the buried portion of the wall
• Retaining or grade work on the cut side where the site calls for it
• Liner, pump, filter, and plumbing hookup
• First fill and a walk-through on running the equipment

What affects the cost in Merritt Island

• How deep the pool is going in. More bury means more excavation, more spoil, and more support work.
• How much fall there is across the yard, and whether the high side can be cut down.
• Soil and water table. Sand, hardpan, rock, and high groundwater each change the excavation.
• Whether the site needs a retaining wall or grade transition on the cut side.
• Access. If a machine cannot reach the area, excavation is slower.
• Spoil handling. Dirt that cannot stay on site has to be hauled away.
• Deck, ladder, or barrier work around the finished pool.
• Pricing for semi-inground installs is listed on our price page.

Every property is different. For a written price on your Merritt Island address, call 321-626-3480.

Why hire a company for this

• A semi-inground wall carries load from the water inside and the soil outside. Backfill and support have to be done in the right order.
• Groundwater sits close to the surface in much of this area. An excavation that fills with water needs handling, not guessing.
• Cutting a slope in without a plan for the exposed side leaves an edge that erodes.
• Not every pool model is rated to be buried, and burying one that is not voids the manufacturer warranty. The model gets checked before a price goes out.
• Workmanship is warrantied in writing.

Nearby

• All services in Merritt Island, FL
• Semi-Inground Pool Installation in Cocoa, FL